If the clock is running slow turn the pendulum nut clockwise to increase the rate.
Pendulum wall clock runs slow.
Pendulum bob with rate adjustment french time and strike.
To slow down the clock loosen the adjustment nut turn it toward your left.
The pendulum disk is moved up or down by turning the adjustment nut.
The bob will settle lower making the effective length of the pendulum longer.
Can we see the movement.
To slow the grandfather clock down move the pendulum disk down by turning the adjustment nut to the left.
Clocks with an interior or exterior pendulum have adjustment screws either on the pendulum or through a hole in the top of the clock.
Increasing the ambient temperature of a clock will slow it down from the expansion and lengthening of the pendulum unless the pendulum is a compensating type.
A pendulum too high causes the clock to run fast.
Adjust the bob at the bottom of the pendulum if the clock is running too fast or slow.
Use the following rules to adjust the pendulum nut.
Push the bob up to make the clock run faster and push the bob down to make it slower.
You may be able to replace the escape wheel with one that has fewer teeth which will require a longer pendulum.
Fixing a clock that runs too fast can be as easy as turning a screw.
Adjust the pendulum up or down.
It may take up to two weeks to properly set a clock that runs fast.
Lengthen the pendulum by turning the screw mechanism to the left 1 2 turn.
If the clock is running fast turn the pendulum nut counterclockwise to decrease the rate.
Denser air causes the pendulum to move more slowly.
The clock will run slower.
Changing the speed of time keeping is accomplished by moving the pendulum disk up or down.
If it does not have a little slt that has and s and f on each side then it can not be adjusted go to walmart or a hobby shop and buy a new closck mechanism.
A clock that runs quickly still works fine.
The movement that s in the clock also does not appear to be a very strung runner rather weak pendulum swing.
Locate the adjustable weight or screw mechanism near the pendulum arm.
Shorten the pendulum by turning the screw mechanism to the right 1 2 turn.
They are cheap and.
It just needs a simple adjustment.